1997 MITSUBISHI GALANT 4DR SEDAN
Security
Battery RED + (+) IGN. HARNESS
Ignition BLK/WHT (+) IGN. HARNESS
Starter01 BLK/YEL + (+) IGN. HARNESS
AllDoorTrigger GRN/RED (-) (-) ABOVE FUSE BOX
TrunkTrigger GRN/BLK (-) (-) TRUNK LIGHT
FactoryAlarmDisarm YEL/WHT (-) DRIVERS KICK PANEL
ParkingLights GRN/WHT (+) (+) GRY PLUG LEFT OF STEERING COLUMN
Remote Start
Battery RED + (+) IGN. HARNESS
Ignition BLK/WHT (+) IGN. HARNESS
Ignition02 BLU/BLK + (+) IGN. HARNESS
Ignition03 +
Accessory01 BLU/WHT + (+) IGN. HARNESS
Accessory02 +
Starter01 BLK/YEL + (+) IGN. HARNESS
AntiTheftSystem NONE
KeySense GRN/YEL (-) (-) IGNITION SWITCH HARNESS
Tach WHT (AC) BLK CONN.ON SIDE OF DIST.
SpeedSense YEL/WHT (AC) DRIVERS KICK 22 PIN PLUG
ParkingLights GRN/WHT (+) (+) GRY PLUG LEFT OF STEERING COLUMN
BrakeLights GRN (+) (+) BRAKE SWITCH
ReverseLights RED/BLU (+) (+) FUSE BOX DRIVERS KICK PANEL
Horn GRN/RED (-) STEERING COLUMN HARNESS
Doorlocks / Window
PowerUnLock RED/GRN (-) (-) BRN PLUG LEFT OF STEERING COLUMN
PowerLock GRN/WHT (-) (-) BLU PLUG LEFT OF STEERING COLUMN
LeftFrontWindow01 LF:RED/BLU
RightFrontWindow01 RF:RED/BLU RR:RED/BLK LR:RED/BLK
LeftRearWindow01 LF:GRN/BLK
RightRearWindow01 RF:GRN/BLK RR:GRN/BLK LR:GRN/BLK
Convenience
HeadLights RED/YEL (-) (-) HEADLIGHT SWITCH
Mobile Audio / Video
Battery RED + (+) IGN. HARNESS
Accessory01 BLU/WHT + (+) IGN. HARNESS
Ground -
Illumination GRN/WHT (+) RADIO HARNESS
Dimmer BLK/YEL (+) RADIO HARNESS
FrontLeftSpeakerPos WHT/BLU
FrontLeftSpeakerNeg BLK/BLU
FrontRightSpeakerPos WHT/RED
FrontRightSpeakerNeg BLACK/RED
RearLeftSpeakerPos YEL/BLU
RearLeftSpeakerNeg GRY/BLU
RearRightSpeakerPos YEL/RED
RearRightSpeakerNeg GRY/RED
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
